WW/TRUCKINGRA

Filed 889W4M read

Signal priority meets a $2.336-per-mile truck cost squeeze

Truck operating costs hit a record $2.336 a mile in 2025. LYT says freight signal priority cut fuel use 11.8% and travel time up to 47% on 26 Alabama intersections.

By
James Calloway
Filed
Length
889 words
Read
4 min
Green lights for heavy-duty fleets: How signal priority is changing urban delivery economics
Green lights for heavy-duty fleets: How signal priority is changing urban delivery economicsjplenio / pixabay

Key points05

  • Average industry truck operating cost reached a record $2.336 per mile in 2025, up 3.4% year over year.
  • Repair and maintenance costs rose 8.6% in 2025 while truckload and refrigerated margins stayed below 1%.
  • Carriers trimmed truck counts by 2.4% and non-driver staffing by 7.8%.
  • One connected-truck study found network-wide fuel consumption fell 11.8% under freight signal priority.
  • A North Texas program estimates 5,000 stops avoided per day saves 3,800 minutes and $1,500; an Alabama pilot across 26 intersections cut travel time up to 47%.

The average industry cost of operating a truck hit a record $2.336 per mile in 2025, up 3.4% from a year earlier, with repair and maintenance climbing 8.6% and truckload and refrigerated margins staying below 1%.

Carriers responded by trimming 2.4% of their truck counts and 7.8% of non-driver staffing. That leaves little slack for the inefficiencies baked into urban routes, including the seconds lost at every red light.

What does a red light actually cost?

A loaded truck that stops sheds momentum and then rebuilds it. Each cycle burns fuel, wears brakes and tires, stresses the transmission. Multiply that across dozens of signals on a single route and hundreds of routes in a fleet, and the cumulative bill gets substantial.

Urban duty cycles compound the problem. Short blocks, closely spaced signals and frequent curbside stops keep trucks from settling into a steady speed, so a large share of every mission goes to accelerating and braking rather than cruising. Repair costs ranked among the fastest-growing line items last year.

Drivers absorb it too. Constant stop-and-go driving breeds fatigue and erodes schedule reliability, which makes tight delivery windows harder to hit. A driver who loses minutes at every light either shortens time at the curb or risks running late. Neither choice serves the driver, the customer or the carrier.

How does freight signal priority work?

Transit signal priority has long helped buses clear intersections by adjusting signal timing. LYT's Freight Signal Priority (FSP) adapts the same concept for trucks: through connected vehicle technology, a truck shares its location, which can extend a green phase or shorten a red phase so the vehicle passes without stopping.

That differs from emergency vehicle preemption, which overrides the signal. Priority requests can be configured to meet each agency's operational needs, balancing vehicle priority against cross-street traffic demand before returning to normal signal timing.

What do the studies show?

One study of connected trucks found network-wide fuel consumption fell 11.8% under freight signal priority. A North Texas planning program estimates that eliminating 5,000 stops per day saves fleets 3,800 minutes of travel time and $1,500 in fuel and operating costs. An Alabama pilot across 26 intersections recorded travel time reductions of up to 47% for participating trucks without disrupting general traffic.

It is not a free lunch. Simulations showed side-street vehicles burning more fuel when green time shifted toward the truck corridor, particularly where truck volumes ran high. As Lyt founder and CEO Tim Menard wrote in his analysis of the technology: "Signal priority is a balancing exercise, not a blanket preference."

Newer "super-intelligent" signal solutions evaluate traffic conditions, anticipate approaching vehicles and optimize timing in real time, helping balance freight movement against the needs of surrounding traffic. Menard previously designed hardware and software simulation systems at Tesla as a firmware engineer before founding Lyt, which sells cloud-based open-architecture smart traffic solutions.

Where the money actually lands

Fuel savings are only part of the value. Delivery commitments depend on consistency, and signal delay ranks among the least predictable variables on an urban route. Cutting it narrows the gap between planned and actual arrival times, which supports service level agreements.

Recovered minutes convert into throughput in congested metropolitan corridors. Drivers can complete more stops within existing hours, lifting route productivity without adding trucks or extending shifts. Fewer unplanned delays also let dispatchers build tighter routes with less buffer time. At a time when carriers cut capacity and staff to protect margins, that is meaningful relief.

What does this mean for electric fleets?

Fleets adding battery-electric trucks have a further reason to care. Georgia Tech research found that on stop-and-go urban routes, electric delivery trucks ran roughly 50% more efficient than diesel equivalents, helped by regenerative braking.

Even so, regeneration recovers only part of the energy spent accelerating. Every avoided full stop preserves range, protects uptime between charges and reduces localized emissions from the diesel trucks still in the fleet.

What has to happen next?

Deployment can move forward in several practical steps:

  • Start with corridors that combine high truck volume and chronic delay, where results will show fastest and public benefits are easiest to justify.
  • Write priority rules that protect cross-street traffic, and tune them using measured outcomes rather than assumptions.
  • Share metrics — stops avoided, fuel used, travel time, emissions — so public agencies and fleet managers judge success the same way.
  • Audit existing telematics platforms for data exchange with local signal systems, and track stops per mile as a routine operating measure alongside fuel and on-time performance.

Can it actually protect margins?

No single technology resolves the cost pressures commercial carriers face. Signal priority, however, attacks a problem fleets have long accepted as unavoidable: the time and energy lost at the intersection. As connected infrastructure expands, cooperation between traffic agencies and fleet operators may prove to be one of the more accessible ways to protect margins, meet delivery commitments and move freight through crowded cities more cleanly.

With carriers already running 2.4% fewer trucks than last year, recovered minutes are the closest thing to capacity a fleet can get without buying a truck, and the pace of connected infrastructure spending will decide how quickly that capacity reaches urban corridors.

Source: fleetowner.com

Share this article:

More from James Calloway

James Calloway

Show full bio

Correspondent covering companies, deals and strategy in Ocean and air freight, container shipping at Waybill Wire.

939 articles

Related05

  1. 3.5 Million Trucks, 12.8 Billion Tons: US Trucking's Scale Meets a Soft Demand Reality

  2. Diesel at $6.29 pushes for-hire trucking costs higher

  3. Diesel at $6.48 a gallon: truckers now burn $3,500 a week on fuel

  4. Trucking costs hit record $2.336 per mile as tariffs squeeze fleets

  5. Truck operating costs hit record $2.37 per mile, ATRI says

« Prev